PROJECTA INTELLI-CHARGE IC3500 35 AMP BATTERY CHARGER
Automatic 12V 35A 7 Stage Battery Charger
With world class 7 stage technology this advanced automatic charger is ideal for the high power demands of caravans and motor homes delivering a comprehensive and accurate charge that gives your batteries longer life and better performance
TYPE 7 stage
INPUT 240VAC, 50Hz
INPUT POWER 1080W
OUTPUT VOLTAGE 12V
OUTPUT CURRENT 2,8,16,35A
MINIMUM START VOLTAGE 2.5A
BACK DRAIN 1mA
DESULPHATION High Frequency Pulse charge up to 11V
SOFT START Half the rated set current up to 12V
BULK Set current up to:
ABSORPTION Constant voltage until current drops to:
2 Amp setting: 0.3A
8 Amp setting: 1.2A
16 Amp setting: 2.4A
35 Amp setting: 5.25A
EQUALIZATION Contact current (2.0-5.25A) up to 16V then hold for 1 hour or 12 hour timeout
ANALYSIS Monitors battery for 90 sec
RECONDITION Contant current (0.3-5.25A) for 4 hours limited to:
MAXIMUM CURRENT 35A
DEEP CYCLE 14-700Ah
TYPES OF BATTERIES
Most types of lead acid batteries including GEL, AGM, WET CELL and CALCIUM
SIZE (MM) 250x81x168
7-STAGE AUTOMATIC CHARGING
This is a fully automatic battery charger with 7 charge stages. Automatic charging protects your battery from being overcharged so you can leave the charger connected to the battery indefinitely. 7-stage charging is a very comprehensive and accurate charging technique that gives your battery longer life and better performance compared to using traditional chargers.
Projecta’s Intelli-Power chargers can be adjusted to suit a number of different battery types including GEL, AGM, WET and Calcium. The chargers can also help restore drained and sulphated batteries.
The 7 charge stages are:
Desulphation; Soft Start; Bulk; Absorption; Analysis; Recondition and Float.
The Desulphation stage is designed to break down sulphation occurring in batteries that have been left flat for extended periods of time, returning them back to full charge.
Sulphation occurs when lead-sulphate hardens and clogs up the battery cells.
This is a preliminary charge process that gently introduces power to the battery, protecting the battery and increasing battery life.
Bulk (Constant Current)
The Bulk stage reduces charging time by charging the battery at the maximum rate (constant current) to a set voltage, at which point the battery is approximately 80% charged.
Absorption (Constant Voltage)
The absorption stage charges the battery to 100% by adjusting the charge rate allowing the battery to absorb more power.
Equalisation (Calcium mode only)
Designed especially for calcium batteries, this stage returns calcium batteries to full service by removing acid stratification of the electrolyte.
The analysis mode tests the battery to ensure that it has taken the charge; if the battery passes the test the charger will proceed to the float stage, but if the battery fails the test, the charger will apply a recondition charge to try to return the battery to full charge.
If after charging, the battery is unable to hold the charge the battery reconditioning function is initiated automatically. This is most likely to take place on batteries that have been deeply discharged, prior to charging. The Recondition mode will then run for 4 hours and at the end will retest the battery. The Intelli-Power battery charger will perform the recondition charge up to 3 times before switching the charging cycle to Float with an error indication.
The Float stage maintains the battery at 100% charge without overcharging or damaging the battery. This means the charger can be left connected to the battery indefinitely.
The Multi-Chem function allows you to set the charging profile to suit each battery’s chemistry type (GEL, AGM, WET and Calcium). This ensures correct and thorough charging and maximises battery performance and battery life.
When Power Supply mode is selected, you can safely run an appliance or load from your battery. An appliance can also be run directly from the battery clamps if required, for example using the charger as a memory saver when disconnecting the battery from the vehicle.
CHARGE STATUS INDICATOR
The CHARGING and FULLY CHARGED LEDs will illuminate and flash in various patterns to indicate the different stages of charging. See below for flash patterns.
Prevents the output leads from sparking due to accidental reverse connection or short circuit making the charger safer to use around batteries.
OVER TEMPERATURE PROTECTION
If the temperature within the charger rises too high, the charger will begin to cool down by turning on the fan, and if the temperature continues to rise it will begin reducing the power output. If still unsuccessful, the charger will shutdown until it cools down.
Using the latest technology in battery chargers, switchmode chargers convert 240VAC power to 12VDC power using electronic components unlike traditional battery chargers that rely on heavy transformers. This allows the charger to be lightweight and compact without sacrificing on performance.
The charger is fitted with a thermostatically controlled fan to cool onboard electronics and maintain charging performance. The cooling fan will engage automatically when there is a high load on the battery or there is sufficient heat build up.
FEATURES OF THE 35AMP
LCD DISPLAY & REMOTE CONTROL*
Control and monitor the charger’s performance from a remote control display, allowing the charger to be mounted out of the way and out of sight. The battery charger and remote are synchronised for operation either locally or by remote.
The temperature sensor monitors the battery temperature and adjusts (compensates) the charger’s output to prevent overcharging. This is ideal for batteries used in warmer climates or environments.
SHORT CIRCUIT PROTECTION
Projecta Intelli-Charge battery chargers feature short circuit protection, even in Power Supply mode. Designed to prevent the output leads from sparking during charging from accidental reverse connection or short circuit,
Projecta gives you peace of mind that the charger will remain safe at all times.
SHOCK PROOF & DUST PROOF
Constructed from extruded aluminium, Intelli-Charge battery chargers are shock-proof, dust-proof and have been rigorously vibration tested and passed both a military and caravan standard.
In addition, the circuit boards have been conformal coated to protect against moisture and dust and other elements so they are suitable for use in a range of locations.
2 YEAR WARRANTY
Australian designed and engineered, quality is guaranteed and all battery chargers include a 2 year comprehensive warranty.
|Unit Of Measure||1|
Be The First To Review This Product!
Help other Award RV Superstore users shop smarter by writing reviews for products you have purchased.